25] What are the differences between Spin and Sweep functions?
(By Pierfrancesco Parente and Robert Byrne)
Spin uses the Z axis of the object as the pivot point and the first and last points should be at the same
X coordinates otherwise the object will be lop-sided. Sweep, on the other hand uses the first and last
points of the outline as the pivot.
Z
. -------
FRONT VIEW . /
. /
. /
. /
. /
X................./...
. /
. /
. /
. |
. |
. |_____
. |
.---------
.
If You Spin this object the top will be closed with its centre offset. If You Sweep it the top
will be open and symmetrical.
You have to remember:
- BOTH Spin & Sweep use the Z axis as the pivot;
- Sweep rotates ALL the points of the outline around the pivot;
- Spin rotates all the points of the outline BUT the first and the
last ones, which just remain in place.
Spin is useful when trying to build a closed top/bottom lathe object (paying care that the first
and the last points of the outline fall right on the Z axis), since Sweep fails in this. Also
Sweep is to be used when the outline to be spun is a closed one (e.g. when making a torus of a
circular outline) since Spin is definitively not recommended for this.
SP & SW always rotate the object along the local Z axis of the object, so You can obtain
different kind of rotations by moving or rotating the object's axes only (select "Transform
Axes Only" in the Transformation Requester or press the Shift button in interactive mode).
![owl-bar](Owl_bar.gif)
Pages made from the amigaguide version with the help of Mike's
RDAG2HTML
and the fabulous Dietmar's GoldED with the
WWW extension v2.